![]() And it doesn't say, "Do this to bring them back," just "do this". I suppose it could just be a dead NEC uPD933 voice chip.ĪDDED: Reading it over again, I suppose it could just be similar to reformatting the Memory Bank otherwise, in the dead battery situation, perhaps you can't write to those 32 slots without the re-initialization. I wish mickrick would pop-in and clarify. And why is this Initialize procedure included in the Service Manual, but not the User Operations Manual? In version 1.0.1 I have added an 'Auto Send SYSEX' option, which means any change you make in VirtualCZ is immediately sent to the hardware, without having to click TOOLS->Send SYSEX. So what is the System Initialize for? Because the way I read it, it was a way of reloading the Preset Bank, like a factory reset, in case of disaster. The CZ Series receive SYSEX for the whole patch at once, so unfortunately it is not possible to automate parameters of the hardware, like you would send a MIDI CC. Is it the Internal 32 Memory Bank user patches? Everyone is saying that they can't be recovered. What is "sound data in the memory bank"? Is it the 32 Preset Bank patches stored in ROM? You guys are indicating that they can't be lost. While pushing the INITIALIZE button, press YES button on the data entry section of the panel.Īll the Memory Bank Data are initialized, then the display shows: SYSTEM INITIALIZED !! " Turn the power switch on, and the display indicates: SYSTEM ALL INITIALIZE (Y/N)?ģ. ![]() Turn the Power Switch off and press the INITIALIZE button.Ģ. ![]() When this happens initialize the unit by the following procedure:ġ. "When the connector from the batteries is disconnected, all the sound data in the memory bank are cleared. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |